I think I've solved my problem...whenever my external USB3 connected storage drive is connected, I get that error message. Whenever I disconnect...
The interface is Serial ATA, SATA/600 Transfer mode.
I've deleted EVERYTHING associated with rF2 from my PC...still having the problem. ISI Support sent me a "ISI Hardware Diagnostic" program....for...
Haven't seen it myself...had to send an email to them...still waiting on a response.
I've been offline for quite a while, so I decided to update rF2. When I opened the Launcher, I had to try and reset my password since it didn't...
After reading this from the first post, I have a question: - Cockpit > No more half carbody mesh for this view, highest carbody LOD is...
I Build 342, no matter what quality/performance settings I was running...I actually gained some (5-10, depending on which settings) FPS with...
My first advice for triple screens would to NOT run in Multiview mode. It eats up quite a few FPS right now. I gain 20+ FPS not running Multiview...
I read that before...it's for a "low poly" Clio which adds up to only a little over 16K for the highest LOD. I was wondering what ISI's...
Is there any sort of guide that states the recommended polygon count for cars being made for rF2?
I gained about 20-25FPS on the average with Multiview off, never thought about turning it off until seeing this thread and the FPS gain. I was...
Ctrl-F's done that cycling through the video loads/FPS thing since rF1...I always used it to check slower rendering areas of tracks before...
Won't get an arguement from me on that, for sure.
Separate names with a comma.
