Hi chaps, I couldn't find anyone with a similar issue but it may have been because the title didn't quite match my searches. For some reason when I put a mod into Dev mode to work with it, the gear ratios are non-adjustable and all the gears are pretty much the same ratio as 1st, so I end up accelerating normally up to the red line in 1st, then all the following gears are the same, giving me the top speed that 1st gear allows for. This makes testing things like aerodynamic wake and slipstreaming parameters difficult as I cannot obtain anything like accurate values. If I load a setup, it loads but the gear ratios remain unchanged; still only allowing you to top out at whatever 1st gear is capable of. You cannot see the gear ratio graph, adjust the ratios or even see what they are. It just says 'N/A' where the ratios would be. Anyone have any ideas? I'm stumped...
