Deadzone

Discussion in 'Technical & Support' started by Oldgamergazza, Aug 5, 2018.

  1. Oldgamergazza

    Oldgamergazza Registered

    Joined:
    Jun 25, 2017
    Messages:
    13
    Likes Received:
    1
    I have a little deadzone, deadzone is at 0 percent, there are very few settings to play with, I have a TS-PC Racer.
     
  2. Alex72

    Alex72 Registered

    Joined:
    Dec 27, 2016
    Messages:
    593
    Likes Received:
    360
    Yes the MINIMUM FORCE where you set FFB strength MULTIPLIER can be raised a little to remove deadzone FFB. Did you test that?
     
  3. Oldgamergazza

    Oldgamergazza Registered

    Joined:
    Jun 25, 2017
    Messages:
    13
    Likes Received:
    1
    Thanks for the reply, I moved it to 6 percent, didn’t notice too much difference, would you recommend more?
     
  4. fsuarez79

    fsuarez79 Registered

    Joined:
    Nov 23, 2016
    Messages:
    323
    Likes Received:
    295
    I also use a TS-PC. Minimum force set at 3%, FFB strength in the Thrustmaster profiler at 70% (if i remember correctly) and the FFB multiplier close to 1.00 in all cars and have no deadzone whatsoever.

    Is it specific to one car or you feel it with all the cars?
    Increase the strength of your wheel if needed but I wouldn't go above 6% for minimum force in a TS-PC.
     
  5. ADSTA

    ADSTA Registered

    Joined:
    Nov 19, 2011
    Messages:
    938
    Likes Received:
    542
    If your wheel starts to oscillate you have too much min force if I remember correctly.
     
    Alex72 likes this.
  6. 2ndLastJedi

    2ndLastJedi Registered

    Joined:
    Nov 3, 2016
    Messages:
    1,298
    Likes Received:
    741
    I thought it was supposed to wobble just a little bit when stationary and if you rest your hand on the wheel it should stop !
     
    Alex72 likes this.
  7. ADSTA

    ADSTA Registered

    Joined:
    Nov 19, 2011
    Messages:
    938
    Likes Received:
    542
    Ok. :cool:
    So long as it's not wobbling when driving. :D
    Unless, of coarse, you're been drinking. :confused:
     
    Alex72 likes this.
  8. patchedupdemon

    patchedupdemon Registered

    Joined:
    Jan 3, 2017
    Messages:
    1,392
    Likes Received:
    899
    Can’t remember where I read it know,but it said to raise min force until your wheel just starts to wobble,and then lower it a click or two
    So yes just on the cusp of wobbling but not
     
  9. Oldgamergazza

    Oldgamergazza Registered

    Joined:
    Jun 25, 2017
    Messages:
    13
    Likes Received:
    1
    Thanks for all the replies, I will try later.
     
  10. Oldgamergazza

    Oldgamergazza Registered

    Joined:
    Jun 25, 2017
    Messages:
    13
    Likes Received:
    1
    I tried it tonight, it was ok, I think it was the cars I was using gt3, ffb generally good tho, I haven’t played RF2 for a while, will be looking for help with a couple of other issues.
     

Share This Page