Discussion in 'General Discussion' started by 88mphTim, Oct 21, 2013.
Friends, I finally made it!
For all skin modders, man do you have a patience!
Until you have finally figured out how to do it and where to start....
It's nothing special, simple but elegant.
With Senna signature and emblem.
What do you say?
Certainly takes patience when you have a lot of stripes to align on different panels, moving the points to align, resave, recheck in the showroom and then redo if not correct also the wire frame isn't always accurate from one side to the next. A tip for you do one side of the car first to get it to your satisfaction and then duplicate that layer and flip it and then move into position on the other side of the car. A lot of people do not realise the time it takes to do a complicated skin. The logos is the easy part of the skin. Have fun with your next skin.
Peter Kyle-Henney and Nathan Harrison.... added to the pack...
Now, now, there is an entire thread about NOT having any F1 cars in rF2. So you'd better take these obviously fake//photoshopped images and place them in the EDITED category where fantasy cars belong....
My third Paint Job!
Not edited. You can capture motion blur from spark by moving freelook camera while taking screenshots, this takes a bit practice.
For example, by facing at car, then move camera a few meters to left. Then holding down Right arrow key and as soon as the car is in camera view, hit screenshot hotkey, and you will get a Linear Motion Blur spark. And you can also use Up & down arrow key to move in & out to capture Zoom Motion Blur spark, there are also other possibilities like using Cam Tilt hotkey to create circular Motion Blur spark, etc.
New PB: 14:05.828
Separate names with a comma.