The pedals are connected through the wheelbase. In the settings i loaded the Fanatec v2.5 profile and when i look at the input diagrams i have input from throttle, brake and clutch, but when i enter a practice session the car doesn’t move when i hit the throttle. Using the shifter paddles the car doesn’t go in another gear, only when i use the Fanatec sq shifter it does change gear but it goes to 2nd, neutral, 2nd, neutral and so on until i put it back in first. (The button mapping of neutral is set to empty)
You may need to manually re-assign your inputs if your wheel is not on 'JOY1'. Click on each input in the list and press the control you want to use when prompted.
Allready did that, like i said i have input from all pedals when i’m In the control settings. Just not when i’m in a car.
Try plugging the pedals into the pc instead,see if that makes a difference. You will get 12bit resolution then also instead of the 10bit when plugged into the wheel base. I have the v3s but have to use them standalone due to having a t300 wheel
Are there any other controllers connected to your pc? If yes, disconnect all others and try then. A 2nd option to try, is to load none of the included profiles. Assign all buttons/keys/pedals manually and safe that settings in an own profile and use that.
None of the above managed to solve the problem, but thanks for trying. The problem was that auto pit was enabled, found out About it when i pressed the “toggle AI driver” button. Never changed those settings so don’t know how it got enabled. Just letting You guys know...