Good morning, Always have my T500rs with 900º in control panel, and 400º in game. When I exit rF2 my steering lock goes back to 900º again automatically. Now it seems that I enter with 900º and exit with 400º, and have to change it back manually. Never happened to me. W10 here, all installed fine, build 1008 lite. Anything that I can try? Thanks in advance!
I have the same issue. T300, 900 in control panel - match car rotation in sim. The car rotation stays in control panel after exiting. Started after the latest build, also updated drivers-firmware at about the same time so not sure if that had an effect.
I have exactly the same issue as Allan. I think it could be the new drivers because every time I start my PC the rotation is reset to 900 even though it was set to 1080 when I switched off. And when I quit rF2 the rotation is set to whatever car I'd just been driving. I have the T300. Sent from my Hudl 2 using Tapatalk
If I remember correctly it used to have your control panel rotation in brackets next to the car rotation degrees now it is blank View attachment 18322
Tested with the firmware 24, driver 2.8.20.0 and no issue, seems the last firmware/drivers have an issue with rF2.
Firmware 24 here, the issue is still here. Well is not really a issue but is not normal. 900 degrees in cp, 400 in game, when i exit rf2 it stays in 400. I have to put it back in 900 manually or reboot the pc. Will try a reinstall of the drivers/firmware.. I hope windows 10 is not doing something in my settings... Enviado desde mi Nexus 6 mediante Tapatalk
I've been in touch with thrustmaster and they acknowledge the issue and are looking into a fix. Sent from my Hudl 2 using Tapatalk