nipzon
Registered
I replaced/upgraded my monitors from 27” 60Hz to 32” 165Hz monitors connected to a single GTX1080ti via three DP cables. Didn’t have any problems before but straight up after connecting the new monitors, the three at random times goes blank and after a few seconds comes back on again. Only one monitor at a time would do this.
After some research I decided to up my EVGA 850 to a 1000W hoping that was it, but no.
Then yesterday replaced the three DP cables with same results connecting to DP1/2 of the monitors.
I have also tried running the monitors at lower frequencies all the way down to 100Hz.
My question is will the GPU in nV surround loose a signal to one monitor and not the others? Is my GPU on the way out? The GPU runs at about 40-50deg while racing, and on default settings.
Could it be the monitors?
After some research I decided to up my EVGA 850 to a 1000W hoping that was it, but no.
Then yesterday replaced the three DP cables with same results connecting to DP1/2 of the monitors.
I have also tried running the monitors at lower frequencies all the way down to 100Hz.
My question is will the GPU in nV surround loose a signal to one monitor and not the others? Is my GPU on the way out? The GPU runs at about 40-50deg while racing, and on default settings.
Could it be the monitors?