Logitech G27 good FF settings

Discussion in 'Technical & Support' started by jonelsorel, Feb 3, 2018.

  1. jonelsorel

    jonelsorel Registered

    Joined:
    Oct 5, 2010
    Messages:
    36
    Likes Received:
    17
    Hi guys,

    I'm having a pretty hard time finding some satisfying FF settings for this game. Is there any G27 user willing to share a good setup for this wheel? It would be truly appreciated.

    At the moment I'm using the following as a base:

    FFB Smoothing 14
    Car Specific FFB Mult 0.30
    FFB Minimum Torque 12%

    Center Spring is disabled in windows settings.

    However.. I can't find any combination that yields proper feedback from kerbs. Gravel and grass are tip top, road feels ok too. I really want to enjoy this gem but it seems like the most important part of it to me (not the graphics) is actually the least straightforward to squeeze pleasure out of..

    Thank you in advance.
     
    Last edited: Feb 3, 2018
  2. Grey

    Grey Registered

    Joined:
    Jul 22, 2016
    Messages:
    12
    Likes Received:
    5
    Increase ffb multi to 1.0 and lower the smoothing. I run 8
     
    jonelsorel likes this.
  3. Louis

    Louis Registered

    Joined:
    Dec 27, 2016
    Messages:
    1,379
    Likes Received:
    838
  4. SPASKIS

    SPASKIS Registered

    Joined:
    Sep 7, 2011
    Messages:
    3,155
    Likes Received:
    1,420
    Can you post an image to your logitech profiler?

    For rF2 settings I use default with slightly reduced smoothing. You may adjust your FFB multiplier to avoid clipping. There was a plug-in for this but it only works for dx9 you would need to use DAM telemetry plugin and check telemetry if FFB output reaches 100% in normal situation (disregard crashing or offroad).
     
    jonelsorel likes this.
  5. jonelsorel

    jonelsorel Registered

    Joined:
    Oct 5, 2010
    Messages:
    36
    Likes Received:
    17
    Thanks guys, will give all tips a try.

    SPASKIS: which screen from it?
     
  6. SPASKIS

    SPASKIS Registered

    Joined:
    Sep 7, 2011
    Messages:
    3,155
    Likes Received:
    1,420
    The configuration one where you set strength, damper, spring...
     
  7. jonelsorel

    jonelsorel Registered

    Joined:
    Oct 5, 2010
    Messages:
    36
    Likes Received:
    17
  8. SPASKIS

    SPASKIS Registered

    Joined:
    Sep 7, 2011
    Messages:
    3,155
    Likes Received:
    1,420
    I would suggest setting damper and spring values to 0. The rest are fine.

    For some reason I don't know Logitech keeps on using a default setting that alteres raw FFB signal.
     
    kimbo and Louis like this.
  9. Louis

    Louis Registered

    Joined:
    Dec 27, 2016
    Messages:
    1,379
    Likes Received:
    838
    and dont forget to put ffb smothing in game at 0 or the lowest you can. That kills the feeling of the surface. Only is bad to some mods because of "rattling" on rumble stripes, but overall feels great
     
    Filip likes this.

Share This Page