Double shift issue

Discussion in 'Technical & Support' started by Jan Jankowicz, May 7, 2019.

  1. Jan Jankowicz

    Jan Jankowicz Registered

    Joined:
    May 7, 2019
    Messages:
    5
    Likes Received:
    3
    Hi guys! I have a problem with my wheel Fanatec Porsche 911 GT3 RS V2 only in rFactor 2. In AC, ACC, PCars, PCars2 and Raceroom, my Fanatec works fine, without such a issue.

    The past problems with some wheels and the double shift issue can't help me.

    In the fileorder under UserData -> player -> player.ison, when i give in "repeat shift", theres possibility from 0 to 5,
    "Repeat Shifts":4,
    "Repeat Shifts#":"0 = no repeat shift detection, 1 = detect and eliminate accidental repeat shifts within 100ms, 2 = 150ms, 3 = 200ms, 4 = 250ms, 5 = prevent shifting again before previous shift is completed",

    - an from 0 to 5 it works better, and the issue get rarer.
    When you have 350ms tolerance, i strongly believe my problem is gone away.

    But this is not possible, or?

    Thx for answer and please pardon my poor english
     
  2. Bernd

    Bernd Registered

    Joined:
    Jul 9, 2013
    Messages:
    1,509
    Likes Received:
    755
    In this case i would say that it is not possible, because the options are predefined. If you could enter your own ms value, it would be possible.
     
  3. Lazza

    Lazza Registered

    Joined:
    Oct 5, 2010
    Messages:
    12,345
    Likes Received:
    6,572
    Are you sure 4 doesn't work for you? Note that 5 only forces the shift to complete, which can be less time than 250ms. 250ms is already quite a long time to wait between shifts.
     
  4. Jan Jankowicz

    Jan Jankowicz Registered

    Joined:
    May 7, 2019
    Messages:
    5
    Likes Received:
    3
    Thx for replay. @ Lazza. Now 4 work...
     
    Lazza likes this.

Share This Page