[SOLVED] Center pivot point

Discussion in 'Track Modding' started by Frankalexandre, May 5, 2018.

  1. Frankalexandre

    Frankalexandre Registered

    Joined:
    Jan 3, 2012
    Messages:
    107
    Likes Received:
    13
    I have thousand of trees on Max that are already pivot point centered, but i believe the pivot point must be bottom centered to billboard work right? How can i do this? There are thousand objects. Thanks.
     
  2. Coutie

    Coutie Moderator

    Joined:
    Oct 5, 2010
    Messages:
    2,500
    Likes Received:
    1,307
    No, you just set that in the exporter, it'll use the bottom of the faces. If you have the triangulation correct. If not, you're most likely screwed. The triangulation needs to be top left to bottom right.
     
  3. Frankalexandre

    Frankalexandre Registered

    Joined:
    Jan 3, 2012
    Messages:
    107
    Likes Received:
    13
    Great...the objects are triangulated right. So i just tick BB over "screen aligned Quads"? Thanks.
     
  4. Coutie

    Coutie Moderator

    Joined:
    Oct 5, 2010
    Messages:
    2,500
    Likes Received:
    1,307
    Ya, make sure you set the bottom. And set the vertex alpha to 0.9999, and then change the vertex colour to something other than white, then change it back to white, sometimes the alpha doesn't take until you reset the colour.
     
  5. Frankalexandre

    Frankalexandre Registered

    Joined:
    Jan 3, 2012
    Messages:
    107
    Likes Received:
    13
    Sorry if it is a rookie question, but how do i set the botton?
     
  6. Coutie

    Coutie Moderator

    Joined:
    Oct 5, 2010
    Messages:
    2,500
    Likes Received:
    1,307
    It's the arrow pointing down I think, if you mouse over them I think it says.
     
    Frankalexandre likes this.
  7. Frankalexandre

    Frankalexandre Registered

    Joined:
    Jan 3, 2012
    Messages:
    107
    Likes Received:
    13
    Thanks Coutie.
     

Share This Page