Hi there I have searched everywhere I have this car downloaded from steam Brabham BT6 Formula Junior I would like to edit the handling and so on of the car :- Spring Rate 275 Lbf/in 300 Lbf/in Ride Height 67 mm under front bulkhead just above bodywork 70 mm under rear of chassis under triangulation tubes Static Camber -1.75 Degrees -0.75 Degrees Droop Minimum 15 mm at dampers at SRH (also fit droop restrictor tab if possible) Minimum 35 mm Castor 4.5 degrees N/A Toe** 0.2 Degrees OUT 0.25 Degrees IN ARB O/D 0.75 in (NEW) 0.5 in ARB I/D 0 in 0 in ARB Lever Arm* 155 mm (NEW) 185 mm (NEW) Dampers SEE NOTES BELOW Tyre Pressures (starting point, refine through temperature) 18 psi HOT 21 psi HOT Bump Rubber KONI 8212 30 mm parallel KONI 8212 40 mm parallel Packers (Damper Clearance @ SRH) 9 mm 25 mm Am aware i may not be able to set it all up, also if anyone can do it am happy to make a small donation if needed.