I don't see anything there.
What sort of fps/what settings were you getting with the 7950?
I don't know that this is the correct subforum to post this, or to grab the attention of the person that has the authority to answer. If not,...
This already exists. You are going to pay, but instructors/driving coaches that work with sim are out there (google Krause & Associates for an...
https://www.oreca.com/en/manufacturer/prototype-oreca-07-en/
When I started using daq in rf1, the basic thing I looked at was throttle/brake usage. If you can add that to a track map you'll see where you...
Why is that unfortunate? The wider field of view is more representative of what you see from the drivers seat without use of multiple monitors or...
Don't put off getting tested. If you turn out to be positive, the lack of oxygen to your brain can interfere with logic and reasoning, further...
While your shocks do not have independent adjustment for high and low, as far as I'm aware for rf, the rates always need to be defined for each....
Ah 7500, that would explain the click and adjustability differences....
If you could re-export with Metric units (N and m/s), it is going to help. Do you have access to the table of data (force measured) @ specific...
Your understanding of "Base" is correct, but whether it is the softest/hardest depends on your damper manufacturer and the sign on the per setting...
This thread's argument amounts to "you're doing it wrong" based on perception. At least four of the vehicles the OP lists as *can* do not have...
Sorry, somehow I missed the reply despite watching the thread. The thing that obfuscates the tooth count for each ratio given is the input shaft...
If you've worked the numbers to get the correct roll stiffness numbers, how do they compare to rates of what I presume are actual spring rates of...
I'm not sure if this is still a thing, but for what I was working on, at one time, had different sets of purchasable springs in the upgrade...
IMO the only way to get the true, correct, ratios is to do the work and get the tooth counts. Sure with rounding, lazy ratios match to the 2nd or...
I converted those points to metric and placed them in 3d space. They appear to be in (Fore-/ Aft+, Up+/Down-, Left-, Right+) notation, if this is...
Without Inventor, getting inertia estimates is going to involve breaking the model down into uniformed material-simple shapes (not very accurate)....
You could start with the older, more simplied, rf1 style, engine ini. It is not like your going to need the newer styled mixture or turbo entries...
Separate names with a comma.
