half FFB rate?

Discussion in 'Technical & Support' started by Twowi, Dec 7, 2018.

  1. Yotan

    Yotan Registered

    Joined:
    Jan 17, 2012
    Messages:
    83
    Likes Received:
    6
    I am using OSW. Recently, the response of shifters and buttons device using teensy LC has been stopped or delayed.
    Although the cause is unknown, I thought that there might be a little possibility of being related to the update frequency of SimuCUBE.
    I had tried peaking and notch filter on SimuCUBE configuration tool. but that was not fixed. It seems to be just a noise filter.
     
    Last edited: Dec 25, 2018
  2. Yotan

    Yotan Registered

    Joined:
    Jan 17, 2012
    Messages:
    83
    Likes Received:
    6
    After that, although I tried variously, delay and response stop occurs in the button using Teensy LC only when there is input of steering. Previously this symptom did not come out. I do not know which is the problem with Windows 10, SimuCUBE Firmware, Teensy LC, rFactor 2.
     
  3. Yotan

    Yotan Registered

    Joined:
    Jan 17, 2012
    Messages:
    83
    Likes Received:
    6
    I found the cause. It seems that the USB cable was broken. The cause was hard to find because the cable was not completely cut off and it was also recognized from the PC. It Improved after I changed the cable.
     

Share This Page