FFB Osw simucube 1

Hi everyone, I just bought a simucube1 Direct Drive with a small mige and a biss-c encoder. Loaded the controller for OSW from rF2 I did not find myself very well. I feel a lot of strength but little detail. Can you be kind enough to recommend your FW and in-game settings? Thank you

 

"Lot of strength but little detail" sounds like your ffb might be clipping. If that's the case you should decrease "ffb multi" in game or "overall strength" in simucube settings.

 

Consider FFB Mult around 0.70 a starting point.

 

Now with the lmp2 in game they are at 0.15 as FFB multi...

 

.70? I'm .50 with my Fanatec v2.5 I even have to turn down FEI I think it is? Last setting in the list.

 

I've an Argon OSW Small MIGE and use near 50% and i know 3 guys with the Simucube and they use the 50% too.

 

I run my SimuCube1 close to max (Hardware output) and between 35-50% game-ffb strength with most titles.
Recon Filter 5-8, depending on game filter options.
Hardware Dampening of 1.5-2.0.

If you notice a lot of spring tension in rF2, try reducing the Direct-Input Spring setting. I have mine at 30%.

 

I don't remember seeing a 'direct input spring' setting? Where is it?

 

I just copied this image from a post here but this is the spring setting mentioned in the SimuCube software.

 

Thanks, I'll try. If someone else still wants to suggest his settings again thank you