2 WIPER

Discussion in 'Car Modding' started by dazzer, Jan 5, 2020.

  1. dazzer

    dazzer Registered

    Joined:
    Feb 3, 2018
    Messages:
    518
    Likes Received:
    1,697
    Hello, so far I have successfully animated only 1 wiper, but now I must use 2 wiper for a vehicle, my question is the following, if I'm not mistaken I should animate the 2 wipers independently and get 2 .gmt and 2 .anm, My question is how to incorporate this into the file. GEN, also how to name the anm since with a single wiper I used the name xxx_wiper.anm, any idea how to order this?
     
  2. Bernd

    Bernd Registered

    Joined:
    Jul 9, 2013
    Messages:
    1,509
    Likes Received:
    755
    I have made a wiper with 2 arms, but it was only 1 mesh with 1 animation.
    Where is the information, that you have to use 2 meshes, coming from?
     
  3. Tommy78

    Tommy78 Registered

    Joined:
    Apr 3, 2012
    Messages:
    630
    Likes Received:
    725
    You can animate at the same time. You need one root boon and connected 4 bones (2 for each Wiper), and the 2 wipers need to be one mesh, just attached them if now separated. So at the end, you have one mesh and one anim, same in the gen file when you have just one wiper.
    The bone names just use xxx_wiper_L_bone01 and 02 for the left, and xxx_wiper_R_bone01 and 02 for the right, each side bones connected to the root bone.
     
    dazzer likes this.
  4. dazzer

    dazzer Registered

    Joined:
    Feb 3, 2018
    Messages:
    518
    Likes Received:
    1,697
    ok ok, i understand
     

Share This Page